主页 > News >

Lifting method of service life of tile press?

Lifting method of service life of tile press?
One, hydraulic components
1 new pressure tile machine use after a month, check the tubing bending or deformation, such as abnormal should be replaced, after two months of use, all parts should be secured connection, this work should be shut down, the system without pressure.
2 monthly cleaning hydraulic components (valve, substrate, motor, pump, tubing, etc.) to prevent dirt from entering the system, you can not use detergent;
Two, hydraulic circuit
1 hydraulic oil for ISOHM46 or MOBILDTE25;
2 system oil temperature should be between 35 to 60 DEG C, shall not exceed 70 degrees, such as high oil and accessories will lead to deterioration and damage.
3 weekly check oil level, such as hydraulic system maintenance should also check the oil level is lower than the oil window should be filled with hydraulic oil;
4 new machine after 2000 hours of work should be oil, after every 4000 to 6000 hours after the oil change, oil change every time, should be cleaning the tank.
Three, filter
1 fuel tank on the air filter, every 3 months to check the cleaning, the best 1 years to replace.
2.. Every time when changing the oil filter should be replaced or cleaned thoroughly;
3 machine related alarm or oily clean and other filter abnormalities should be replaced;


KEY WORDS

Roll Forming Machine,Tile making machine,Roofing sheet forming machine,cold roll forming machine,Glazed tile forming machine

CONTACT US

Phone:0086+18231737651
Cangzhou Dixin Cold Bending Equipment Co., Ltd